Links
|
|
|
|
Manuscript Format
Over the years, publishers have developed
certain standards to make their jobs easier.
Manuscript format is one of them, and something
that often creates some heated discussion in
various newsgroups. There are several points
that you need to remember:
- The standards are there for a reason. They
are not arbitrary and are generally set up
to make certain jobs easier.
- It's not your job to design the
manuscript. You supply the words; the
publisher supplies the format.
- You don't have to stick to the format
except in the final version. If you prefer
something else in your drafts, fine. It's
simple to change the font once you're
printing out the final version.
- The wrong format or font won't destroy
your chances; it may not even hurt. It a
question of whether you're willing to take
the chance that you're writing is good
enough to overcome the difficulties you'll
cause by not doing things properly.
- As a personal aside, I've noticed the
people who fight hardest against the
standard format usually end up using Times
Roman instead -- which, on most computers,
is the default font that comes up
automatically. Hard to believe they've put
much thought into their choice.
That stated, here are the rules for standard
format:
- Manuscripts must be typed, double-spaced,
on one side of the paper, with wide enough
margins (min. 1-in.) for the editor to make
notations.
- Fonts (and here's where the fights occur):
The preference is for monospaced fonts --
fonts where all letters are the same width.
The most commonly used monospaced font is
Courier; the most commonly preferred size is
12 points (also called 10 pitch -- 10
characters to the inch). This is a hangover
from the days before computers, when most
typewriters used what was known as
"Pica" type -- essentially 12
point Courier. It is also acceptable to use
a 10-point monospaced font like Prestige
Elite -- again, a hangover from typewriter
days, when you could buy "Elite"
typewriters that used 10-point (12 pitch-- I
know, it's confusing) Prestige. The actual
font is less important (as long as it's
large and dark enough) as the fact that it
must be monospaced; proportional fonts screw
up word counts.
- No fancy formatting within the manuscript.
Indent each paragraph five spaces (1/2 in.).
Indicate italics by underlining (do not use
italics; they are easily missed). Indicate
boldface by drawing a wavy line beneath the
text and writing "bf" in a circle
in the margin. Do not hyphenate words (the
typesetter will include the hyphen so the
word might read "Schenec-tady").
Do not right justify the text (you may like
it, but it's harder to read -- especially on
long paragraphs -- and it messes up word
counts).
- Indicate a blank line by placing a # in
the center of the line. The # indicates
space to a typesetter.
- At the top of the first page, type your
name (the one you want them to write the
checks out to) and address at the upper left
corner. Type the word count at the upper
right corner Skip down to the middle of the
page. Type the title of the story, centered
(optionally: ALL CAPS). Go down a line. Type
"by Your Name" (if you want to use
a pen name, type it here; the check will be
sent to the name at the upper left). Go down
another line and begin the story.
- Don't put on a copyright notice. It's
unnecessary. You also don't have to
indicate the rights offered. Most magazines
tell you what they're buying; if you don't
like it, don't submit to them. Don't write
"Approximately" by the word count.
Editors know the word count is approximate.
- On each additional page, put your last
name and the page number in the upper right
corner: Name/2
You can also include a keyword from the
title of the story: Name/Keyword/2, but this
is optional -- it's rare that you have two
manuscripts in a position when they can be
mixed up, and if at the last minute you
decide to retitle your novel, you only have
to change the title page instead of printing
out the entire thing with the correct
keyword.
- At the end of the story, center the word
"end".
|
|
Return
to top
|
|